Hi,
We have recently bought Englefield Valencia shower (tray, walls, door). We had tradesman install it, but I'm not quite happy with the result. There are couple of things I have concerns about and wanted to see if anyone had opinion if these are acceptable deviations / tolerances.
Firstly, one of the corners isn't square, it is about 5-10mm out, so back wall is curved, it is noticeable though when you walk into the shower... Also it seems like where that back wall is curved it is not making contact with the tray and seems like silicone seal may not be completely watertight...
Secondly, door retainers aren't flat against the liner when looked at from the inside of shower. These are properly sealed from outside but there are gaps on the inside (it could be perfectly OK, I don't know). Also one side retainer has been screwed into the GIB rather then stud.
I have attached a few photos so you have better understanding, and hope someone can provide advice.
We have recently bought Englefield Valencia shower (tray, walls, door). We had tradesman install it, but I'm not quite happy with the result. There are couple of things I have concerns about and wanted to see if anyone had opinion if these are acceptable deviations / tolerances.
Firstly, one of the corners isn't square, it is about 5-10mm out, so back wall is curved, it is noticeable though when you walk into the shower... Also it seems like where that back wall is curved it is not making contact with the tray and seems like silicone seal may not be completely watertight...
Secondly, door retainers aren't flat against the liner when looked at from the inside of shower. These are properly sealed from outside but there are gaps on the inside (it could be perfectly OK, I don't know). Also one side retainer has been screwed into the GIB rather then stud.
I have attached a few photos so you have better understanding, and hope someone can provide advice.
Comment